(last revised 31 March, 2008)
The Nanometrics servers NaqsServer and DataServer can provide on-line access to seismic data and state-of-health information accepting TCP/IP connections and forwarding the requested data to each client program. NaqsServer collates and stores in near-real-time incoming data in ringbuffers whereas DataServer provides data of the past stored in NaqsServer ringbuffers. In order to implement the Nanometrics subscription protocols, the author developed a software consisting of a library called libnmxp and a tool called nmxptool. The library exposes a set of documented APIs which allow to communicate with the Nanometrics servers. The tool, based on libnmxp, allows to retrieve or monitor real-time data and data of the past.
nmxptool can be used in three different ways:
Why a new software client for Nanometrics Server?
When we connect to a NaqsServer by a Short-term data stream connection we get a gap for each retransmitted packet. Unfortunately, previous available software were not able to reorder retransmitted packets. nmxptool is capable to manage a buffer of packets and order them chronologically when is needed, that is when a retransmission occurs. The management of this buffer reduce number of gaps in spite of the increment of latency. However, some tests showed that almost all packets are retrivied maximum within 60 seconds.
Main parameter to set for Raw Stream is the max tolerable latency you can accept, a sort of short-term-completion but managed by the client and not by the server.
Moreover, nmxptool is capable of:
The maximum size of the TRACEBUF messages created by nmxptool is limited to the maximum number of samples that can fit into a Nanometrics compressed packet (17 * N, where N is any odd integer from 1 to 59, that is 17 * 59 = 1003 samples = 4012 bytes), plus the size of the TRACEBUF header (64 bytes). So 4076 bytes is a good estimate of the maximum size of TRACEBUF messages created by nmxptool.
nmxptool supports the creation of either TRACEBUF or TRACEBUF2 messages depending on which version of Earthworm the module was built for. By default the module will create TRACEBUF2 messages if the system supports them and TRACEBUF messages otherwise. Additionally there is an optional command ForceTraceBuf1 that will force the use of TRACEBUF messages on systems that support TRACEBUF2.
nmxptool is open-source and actively supported by the
Istituto Nazionale di Geofisica e Vulcanologia. (Author: Matteo Quintiliani)
Module Index | nmxptool Commands